A box of air... SMD SD-1

[laurie]

I was expecting surface mount, but this is a whole lot of empty space.
.

Boss SD-1 SMD.jpg (454.61 KiB) Viewed 11630 times

[Pepe]

I use the term "stamp-sized circuit boards" in my ads when selling BOSS pedals with through-hole circuit boards. This is really a sad view, isn't it? If BOSS only used a slightly bigger board with a few bigger solder points that the most modifications use, then I wouldn't complain. At least not as loudly.

[bigtone23]

Boss could offer smaller format pedals with that circuit board.
SD-1M(ini)

[Zerksies]

I use to mod a lot of pedals and seen this is a DS-1 years ago

[fuzzbuzzfuzz]

Room for another circuit in there, like a "Bad Bob" etc.

[bigtone23]

Room for another circuit in there, like a "Bad Bob" etc.

This is a very good idea. Adding a simple circuit would be pretty cool!
It's quite possible to drop an EMG SPC/EXG/RPC/VMC/EXB module in there with a little ingenuity. These would play great with the buffered, instrument level nature of the pedal, plus they don't draw a ton of current, so powering them is easy, too.
Hmm... A VMC in a SD1...

[fuzzbuzzfuzz]

Room for another circuit in there, like a "Bad Bob" etc.

This is a very good idea. Adding a simple circuit would be pretty cool!
It's quite possible to drop an EMG SPC/EXG/RPC/VMC/EXB module in there with a little ingenuity. These would play great with the buffered, instrument level nature of the pedal, plus they don't draw a ton of current, so powering them is easy, too.
Hmm... A VMC in a SD1...

indeed. Plenty of possibilities. even a simple footswitch do de-gain or add-mids..

[bigtone23]

I was just thinking about the Wilde Q Filter. I use one on a bass, tuned the cap and resistor with the 500K pot to get as close to a variable 450Hz cut as possible. It's a really cool passive EQ control. Could be an option.