ES-8 questions

[insch]

I am setting up my ES-8 but have got a bit stuck on a few issues:

1) How to change the final output of a loop. I have L & R outputs set up on the ES8 and have created a parallel loop at one point in the chain but I can't see how to route its output to R rather than L.

2) I have a Superego+ pedal (the one in parallel that I'd like to route to the R output channel) and a Strymon TimeLine. I also have two volume pedals with one pre-ES8 for sweeps and the other in the chain. I also have a mini expression pedal. I'd like to be able to control the mix level of the TL so that I can bring delays in or out with a volume/exp pedal. The TL pedal is in the main chain. I am trying to work out the best way to use my two controller pedals in the ES-8 chain. Right now I am using the second volume pedal on the parallel path with the Superego+ so that I can control the additon or not of that pedal's output to the setup. My mini EXP pedal is also currently connected to the Superego+ but unfortunately will not control the volume of that pedal if its onboard effects are operating (it will then control effect speeds etc). So I have had to dedicate a volume and EXP pedal to the Superego+. The TL has MIDI and I have an external Multi box if required. It would be nice to be able to control delay times on the TL but the main issue is to be able to control the level of delays in the chain. I am getting a bit confused.

Any advice on the above would be truly great. Some pix attached. Thank you!

[insch]

IMG_6191.jpeg (163.81 KiB) Viewed 6075 times

IMG_6192.jpeg (110.92 KiB) Viewed 6075 times