Fender blackface Vibrolux

[laurie]

It has taken a big hit on the knobs. On the vibe controls. Front panel is bent.
.

20250321_103715.jpg (132.29 KiB) Viewed 8715 times

[laurie]

Easily fixed but annoying.

[laurie]

This is the knob that took the hit that bent the frame.
.

20250321_220048.jpg (167.83 KiB) Viewed 8681 times

[laurie]

Frame is straightened. I made a tool that let me pull the top lip back to the right position.
.

20250321_162606.jpg (192.2 KiB) Viewed 8681 times

[Pepe]

Great!

[laurie]

I noticed that some of the work done before I got the amp isn't up to standard. This is the quality of the solder joints on the recap of the bias capacitor.

Additionally, during the recap the wire was burned by poor workmanship, and then just left. This shoddiness pisses me off, and there is no need for it.

Bad joint:

Joint1.jpg (136.44 KiB) Viewed 8661 times

Burned wire:

Burned wire.jpg (181 KiB) Viewed 8661 times

New Sprague capacitor and cleaned up joints and wiring:

Clean recap.jpg (127.99 KiB) Viewed 8661 times

[laurie]

This is the knob that took the hit that bent the frame.
.

20250321_220048.jpg (167.83 KiB) Viewed 8659 times

A little bit of heat from the heatgun and some patience and I've been able to mostly restore this knob:
.

Knob fixed.jpg (95.23 KiB) Viewed 8660 times

[Pepe]

Wow! I hadn't thought that this could work. Great tip!

[laurie]

Another annoyance - one of the bypass caps was burned when the recap was done. Again, no excuse for this.
.

burned cap.jpg (46.67 KiB) Viewed 8506 times

[laurie]

Bypass caps all replaced with some very nice Sprague 25mfd caps that I was able to source.
.

new caps.jpg (273.46 KiB) Viewed 8506 times