Boss ES-5 how do I set the leds to sync to which pedal has been pressed

Post Reply
dubsystm
Posts: 1
Joined: Mon Oct 18, 2021 12:31 pm

Boss ES-5 how do I set the leds to sync to which pedal has been pressed

Post by dubsystm » Mon Oct 18, 2021 1:19 pm

I have recently done a factory reset on my Boss ES-5 and have gone to re-configure but I'm completely stuck.

The way I had it set up was the signal chain went from right to left so when I pressed switch 5 it engaged loop 1, switch 4 did loop 2 etc. This was so the switch lined up with where the pedals were located on my board. The led lit up to show the switch was engaged.

Since the reset I cannot get the led to show when the switch is engaged, the led for the loop lights up instead. So I click switch 5, it activates loop 1 but lights up switch 1. This is not how I had it set and is very confusing to me. I can't for the life of me remember how I initially configured it and have tried all manner of settings.

Any ideas? It must be something simple as I don't remember having any issues when I first configured it

Post Reply