Yesterday I received another one of these pedals and today I disassembled and cleaned it. Although I have always noticed it whenever I had opened such a pedal, this time I was completely curious what this connector with the yellow wire leading from pin 1 to pin 3 ('CN8A') might be doing. So I carefully pulled that noose and powered the unit. While it stays absolutely normal in bypass mode this way, the input signal vanishes as soon as you engage the effect. The Level knob still defines the volume of the delay, but the dry signal is completely cut and not mixed in at 100% anymore. Oh, yeah!

This way the pedal can be used in the send/receive effect loop of a mixing console, and with the proper signal routing dry/wet stereo is possible, too. I doubt that this was an intended feature, as it isn't explained in the manual. I rather think that it was made for testing the units at the factory. Anyway, this is a very cool function that I had loved to know when I made the demo video years ago (see below). Everything it requires is to remove the six small screws of the enclosure, open the pedal (be careful with the battery connector, in case you want to use it) and remove that connector.